Solders
ZINC DIECAST - White Metal - POT METAL & ALUMINUM!
Simply bead blast the casting, and/or drill out the
pits with a Dremel tool or die grinder. Inject enough
SOLDER-IT into the hole to just overfill it. Then, using
the tip of a small torch flame, gently heat the area
until the paste flows. The special fluxes and cleaning
agents incorporated into the paste will fuse the molten
solder to the casting to provide the perfect repair.
SOLDER-IT is a perfect color match for Pot Metal, and
any join lines should readily buff out. Sand flat and,
if required plate with copper
plate.
The finished repair has a tensile strength of up to
22,000psi, so can be used to join and repair broken
sections of the casting. The Zinc Metal Solder Paste.
Solders ZINC DIECAST - White Metal - POT METAL &
Aluminum ! No Mess, No Waste syringe applicator. Works
with the heat of a torch or soldering iron. Low melting
point - 400°F. (Melts before the pot metal does!)
|
